Xtorm XP2SW060 Manual

The Xtorm XP2SW060 is a high-performance portable power station designed for outdoor adventures, emergency backup, and mobile power needs. Featuring a 600Wh capacity, multiple output ports (AC, DC, USB), pure sine wave inverter, MPPT solar charging, LCD display, and lightweight design. Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Lithium-ion battery pack, Pure Sine Wave Inverter, LCD Display, Multiple output ports, Solar charging input, Car charging input.

Feature	Description
AC Output	Pure sine wave 230V/50Hz, 600W continuous power
DC Output	12V/10A car port for DC devices
USB Outputs	2x USB-A (5V/2.4A), 1x USB-C PD (60W)
LCD Display	Shows battery level, input/output power, remaining time
Solar Charging	MPPT controller, max 200W solar input
Car Charging	12V/24V vehicle adapter input
Wall Charging	AC adapter for fast charging from mains
Overload Protection	Automatic shutdown on overload or short circuit
Battery Management	BMS for overcharge, over-discharge, temperature protection
Portable Design	Lightweight with carrying handle

Installation & Setup

Unpack and inspect contents. Place on stable, dry surface.

1. Initial Charge: Connect AC adapter to wall outlet and power station.
2. LCD Check: Verify display shows charging status and battery percentage.
3. Output Connection: Connect devices to appropriate ports (AC, DC, USB).
4. Solar Setup: Connect compatible solar panel to DC input (use MC4 to XT60 cable).

WARNING! Keep away from water and heat sources. Do not disassemble unit.

First-Time Use

Power on unit; check LCD display.

1. Charge fully: Use AC adapter for initial 8-hour charge.
2. Test outputs: Connect small device to USB port to verify operation.
3. Configure settings: Press and hold power button for 3 seconds to access settings menu.
4. Monitor battery: LCD shows remaining capacity and estimated runtime.

CAUTION! Use only approved cables and accessories. Do not exceed rated power.

Specifications

• Capacity: 600Wh (16.8Ah @ 35.7V).
• Battery Type: Lithium-ion (LiFePO4).
• AC Output: 230V~50Hz, 600W continuous (1200W surge).
• DC Output: 12V/10A (max 120W).
• USB Output: USB-A: 5V/2.4A, USB-C PD: 60W.
• Input: Solar 12-60V/200W max, Car 12V/24V, AC 230V/50Hz.
• Charging Time: AC: 6-8 hours, Solar: 4-8 hours (depending on conditions).
• Weight: 7.5 kg.
• Operating Temp: -10°C to 40°C.
• Storage Temp: -20°C to 45°C.

Controls and Indicators

Front Panel: Power Button, LCD Display, Output Ports.

LCD Display: Shows battery percentage, input/output power, remaining time, error codes.

Power Button: Short press to turn on/off outputs; long press (3 seconds) for settings menu.

Indicator Lights: Green (charging), Blue (discharging), Red (error/fault).

Settings Menu: Battery saver mode, LCD brightness, auto-shutdown timer.

Charging Methods

AC Wall Charging: Use included AC adapter. Solar Charging: Connect compatible solar panel. Car Charging: Use 12V/24V car adapter.

1. Ensure power station is turned off before charging.
2. Connect charging cable to appropriate input port.
3. LCD will show charging status and estimated time to full.
4. Disconnect when fully charged (100% indicated).

Tip: For optimal battery life, avoid frequent deep discharges below 20%.

Powering Devices

Supports laptops, phones, lights, small appliances, cameras, etc.

1. Check device power requirements (watts/volts).
2. Connect device to appropriate port (AC, DC, USB).
3. Turn on power station (press power button).
4. Turn on device; monitor battery level on LCD.
5. For multiple devices: Ensure total power does not exceed 600W.
6. Auto-shutdown: Unit turns off after 30 minutes if no load detected (configurable).

WARNING! Do not connect high-power devices like heaters, air conditioners, or power tools.

Safety Features

Overload Protection: Automatic shutdown if load exceeds 600W. Short Circuit Protection: Cuts output on short circuit. Temperature Protection: Reduces charging current if overheated. Low Voltage Protection: Shuts down at 10% battery to prevent damage.

Care & Maintenance

Store in cool, dry place. Clean with dry cloth only; do not use liquids.

CAUTION! Do not expose to direct sunlight for extended periods. Recharge every 3 months if storing long-term.

Regulatory Information

CE, RoHS, FCC compliant. Contains lithium-ion battery; follow local disposal regulations. Copyright © 2025 Xtorm; trademarks of Xtorm BV. For support, visit www.xtorm.com or contact +31 20 123 4567.

Troubleshooting

Symptom	Possible Cause	Corrective Action
No power output	Battery empty/unit off	Charge battery; press power button to turn on.
Device not charging	Wrong port/cable	Use correct port; check cable connection; verify device compatibility.
LCD shows error code	Overload/overheat	Disconnect devices; let unit cool down; restart.
Slow solar charging	Low sunlight/angle	Reposition solar panel; ensure direct sunlight; check cable connections.
Battery drains quickly	High power device	Check device power consumption; reduce number of connected devices.

Reset: Hold power button for 10 seconds to force restart.

Service: +31 20 123 4567; www.xtorm.com/support