Waka Waka SOLAR PANEL Manual

The Waka Waka SOLAR PANEL is a portable, high-efficiency solar charging device designed for outdoor and emergency use. It features a foldable design with multiple solar panels, built-in battery storage, USB output for charging devices, LED indicators, water-resistant construction, and integrated flashlight/reading light. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Charging & Power Management 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Foldable solar panels, Power Bank battery unit, USB output port, LED power indicators, ON/OFF switch, Flashlight/Reading light button, Carrying handle.

Feature	Description
Solar Panels	High-efficiency monocrystalline cells for fast charging
Power Bank	Built-in lithium-ion battery for energy storage
USB Output	5V/2A port for charging phones, tablets, and other devices
LED Indicators	4-level battery status lights (25%, 50%, 75%, 100%)
ON/OFF Switch	Controls power flow to connected devices
Flashlight Button	Activates integrated LED light (steady and SOS modes)
Reading Light	Adjustable brightness for close-up illumination
Carrying Handle	Integrated handle for easy transport
Water Resistance	IPX4 rated for protection against splashing water
Foldable Design	Compact folding for storage and portability

Installation

Unpack and inspect contents. Ensure all components are present.

Unfold solar panels: Gently unfold all panels to maximum surface area.
Position for sunlight: Place in direct sunlight, angled towards the sun for optimal charging.
Connect power bank: Ensure the power bank unit is securely attached to the panel connector.
Check LED indicators: Verify that charging indicator lights are active.

WARNING! Do not expose to extreme temperatures. Keep away from water sources when unfolded for charging.

First-Time Setup

Initial charging and device preparation.

Fully charge battery: Place in direct sunlight for 8-10 hours until all LED indicators are lit.
Test flashlight: Press flashlight button to activate and cycle through modes (steady/SOS).
Connect device: Use included USB cable to connect your phone or device to the USB port.
Monitor charging: LED indicators will show remaining battery power during use.

CAUTION! First charge requires full sunlight exposure. Partial charging may reduce initial capacity.

Specifications

Solar Panel: Monocrystalline, 5W output.
Battery Capacity: 5200mAh lithium-ion.
Output: USB 5V/2A (10W max).
Charging Time: 8-10 hours (full sun), 5-6 hours (wall charger).
Device Charging: Smartphones: 1-2 full charges; Tablets: partial charge.
Light Modes: Flashlight (high/low), Reading light, SOS strobe.
Water Resistance: IPX4 (splash proof).
Operating Temperature: -10°C to 45°C (14°F to 113°F).
Weight: 450g (0.99 lbs).
Dimensions (folded): 195 x 135 x 25 mm.

Controls and Settings

Power Bank Unit Controls: ON/OFF switch, Flashlight button, LED indicators.

LED Indicators: 4 blue LEDs showing battery level (25% per LED). Flashing during charging, steady when fully charged.

Flashlight Operation: Press once for high beam, twice for low beam, three times for SOS mode, press and hold for reading light.

Charging Modes: Solar charging (auto-detect), Wall charger input (via micro-USB port).

Connecting Devices

USB charging for smartphones, tablets, GPS devices, cameras, and other USB-powered devices.

Ensure power bank has sufficient charge (check LED indicators).
Use appropriate USB cable for your device.
Connect device to the USB output port.
Turn ON/OFF switch to "ON" position.
Device should begin charging automatically.

Tip: For fastest charging, turn off device being charged or enable airplane mode.

Charging & Power Management

Supports simultaneous solar charging and device charging.

Solar Charging: Unfold panels, position in direct sunlight. LED indicators will flash during charging.
Wall Charging: Connect micro-USB cable to power bank and wall adapter for faster charging.
Battery Protection: Built-in circuit prevents overcharging, over-discharging, and short circuits.
Power Saving: Unit automatically enters sleep mode after 30 seconds without load.
Charge Monitoring: LED indicators show remaining capacity (4 lights = 100%, 3 lights = 75%, etc.).

WARNING! Do not attempt to charge non-USB devices. Use only approved cables and adapters.

Safety Features

Overcharge Protection: Automatically stops charging when battery is full. Over-discharge Protection: Prevents battery damage from complete drainage. Short Circuit Protection: Built-in safety circuit. Temperature Control: Reduces charging rate in high temperatures.

Care & Cleaning

Keep solar panels clean for optimal performance. Use soft, dry cloth to wipe panels. Store in cool, dry place when not in use.

CAUTION! Do not use chemicals, abrasives, or water jets for cleaning. Do not fold panels when wet.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits. CE certified for European market. RoHS compliant (Restriction of Hazardous Substances). Copyright © 2025 Waka Waka; all rights reserved. For support, visit www.waka-waka.com or contact [email protected].

Troubleshooting

Symptom	Possible Cause	Corrective Action
Not charging via solar	Insufficient sunlight/panel dirty	Move to direct sunlight; clean panels with dry cloth.
Device not charging	Cable/connection issue	Try different USB cable; ensure ON/OFF switch is ON.
LED indicators not working	Battery completely drained	Charge via wall adapter for 2 hours, then try solar.
Flashlight not working	Battery depleted/button issue	Charge unit; press and hold button for 3 seconds.
Slow charging	Weak sunlight/old battery	Reposition for optimal sun; consider battery replacement if older than 2 years.

Reset: Disconnect all devices, charge fully, then restart.

Service: [email protected]; www.waka-waka.com/support