Sunjoy N101000700 Manual

The Sunjoy N101000700 is a versatile outdoor heater designed for patios, decks, and other outdoor living spaces. It features a durable steel construction, adjustable heat settings, safety tilt switch, easy push-button ignition, and weather-resistant components. Powered by a standard 20 lb propane tank (not included), it provides efficient heating for gatherings and cool evenings. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Steel body with powder-coated finish, Burner Assembly, Control Knob, Piezo Igniter, Heat Reflector, Safety Tilt Switch, Propane Regulator Hose, Wheels for mobility.

Feature	Description
Steel Construction	Durable, weather-resistant powder-coated finish
Adjustable Heat Control	Knob with High, Medium, Low, and Off settings
Piezo Igniter	Push-button ignition for easy, matchless start
Safety Tilt Switch	Automatically shuts off gas if heater is tipped over
Heat Reflector	Directs heat outward for efficient warming
Propane Regulator Hose	Connects to standard 20 lb propane tank (not included)
Wheels	Two wheels for easy relocation on flat surfaces
Carry Handle	Integrated handle for lifting and positioning
Burner Cover	Protects burner from debris when not in use
Assembly Tools Included	Wrench and screws provided

Assembly Instructions

Unpack all parts and check against parts list. Assemble on a clean, flat surface.

1. Attach Wheels: Insert axle through wheel brackets, secure with provided clips.
2. Install Legs: Bolt legs to base using included hardware and wrench.
3. Mount Burner Assembly: Place burner onto base, secure with screws.
4. Attach Heat Reflector: Position reflector over burner, fasten with screws.
5. Connect Control Panel: Mount knob and igniter to front panel.
6. Attach Propane Hose: Connect regulator hose to gas valve (hand-tighten only).

WARNING! Do not force parts. Ensure all connections are secure before use. Keep heater upright during assembly.

First-Time Setup

After assembly, prepare for first use.

1. Check for Leaks: Apply soapy water to gas connections; bubbles indicate leak—tighten or replace.
2. Connect Propane Tank: Attach regulator to tank valve (turn counterclockwise until snug).
3. Place Heater: Position on stable, level, non-flammable surface outdoors, away from overhead cover.
4. Clear Area: Ensure minimum 3 feet clearance from walls, furniture, and flammable materials.
5. Test Ignition: Turn knob to OFF, open propane tank valve, then follow lighting instructions.

CAUTION! Use only outdoors in well-ventilated area. Never use indoors or in enclosed spaces.

Specifications

• Model: N101000700
• Heat Output: Adjustable, up to 40,000 BTU/hr
• Fuel Type: Propane (LPG)
• Tank Compatibility: Standard 20 lb propane tank (not included)
• Ignition: Piezo electric push-button
• Safety Features: Tilt switch, oxygen depletion sensor (if equipped)
• Construction: Steel with powder-coated finish
• Dimensions (Approx.): 36" H x 18" W x 18" D
• Weight: 25 lbs (without propane tank)
• Warranty: 1-year limited warranty

Controls and Operation

Control Knob: OFF, PILOT/IGNITE, LOW, MEDIUM, HIGH. Piezo Igniter Button: Press to spark pilot.

To Light Heater:

1. Ensure knob is in OFF position.
2. Open propane tank valve slowly.
3. Push and turn knob to PILOT/IGNITE.
4. Press and hold Piezo button until pilot lights (visible through viewport).
5. Keep knob pressed in for 30 seconds after pilot lights, then release.
6. Turn knob to desired heat setting (LOW, MEDIUM, HIGH).

To Turn Off: Turn knob to OFF. Close propane tank valve.

Adjusting Heat: Rotate knob between LOW, MEDIUM, HIGH. Allow flame to stabilize after adjustment.

Connecting Propane Tank

Use only standard 20 lb propane tank with OPD (Overfill Protection Device) valve.

1. Ensure heater is OFF and cool.
2. Inspect hose and regulator for damage before each use.
3. Connect regulator to tank valve by turning coupling counterclockwise until snug.
4. Do not use tools; hand-tighten only.
5. Check for leaks with soapy water solution as described in First-Time Setup.

Tip: Store propane tank upright in a cool, well-ventilated area outdoors. Never store spare tanks near heater.

Safety Features

Tilt Switch: Automatically shuts off gas supply if heater is tipped more than 15 degrees from upright.

Oxygen Depletion Sensor (ODS): If equipped, automatically shuts off heater if oxygen levels drop below safe threshold.

Important Safety Rules:

• FOR OUTDOOR USE ONLY.
• Never leave heater unattended while in operation.
• Keep children and pets at least 3 feet away.
• Do not use under overhead cover, inside tents, garages, or buildings.
• Do not move heater while it is on or hot.
• Allow heater to cool completely before covering or storing.

Maintenance & Storage

Regular Maintenance:

• Before each use, inspect hose, regulator, and burner for damage, insects, or debris.
• Clean burner ports with a soft brush if clogged.
• Wipe exterior with a damp cloth; do not use abrasive cleaners.
• Check and tighten connections periodically.

End-of-Season Storage:

1. Disconnect propane tank and store separately.
2. Clean heater thoroughly and allow to dry.
3. Cover burner with provided cover.
4. Store in a dry, protected location.

CAUTION! Always disconnect propane tank before performing any maintenance. Never attempt to repair gas valve or regulator—contact authorized service.

Regulatory Information

This heater complies with ANSI Z21.97/CSA 2.41 for outdoor gas heaters. It is certified for outdoor use only. Use only with propane gas. The regulator and hose assembly must be replaced if damaged. For replacement parts or service, use only authorized components. This product is covered by a 1-year limited warranty. For support, contact Sunjoy Customer Service or visit the manufacturer's website.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Heater will not light	No gas, blocked burner, wet igniter	Check propane tank level; ensure valve is open. Clean burner ports. Allow igniter to dry if wet.
Pilot lights but goes out when knob is released	Faulty thermocouple, insufficient gas flow	Hold knob longer (60 sec). Ensure gas valve is fully open. Check for kinked hose.
Weak flame or low heat	Low gas pressure, partially closed tank valve, obstructed regulator	Use full tank. Open tank valve fully. Check for spider webs in burner tube.
Heater shuts off unexpectedly	Tilt activated, high wind, low oxygen	Place on level surface. Use in sheltered area. Ensure outdoor ventilation.
Gas odor	Leak	Turn off heater and tank immediately. Check connections with soapy water. Do not use until leak is fixed.

Reset: Turn knob to OFF, wait 5 minutes, then relight following instructions.

Service: For issues not resolved above, contact Sunjoy Customer Service. Do not disassemble gas control valve.