Somogyi Elektronic Home FLP 1000 SOLAR Instruction Manual

The Somogyi Elektronic Home FLP 1000 SOLAR is a portable solar-powered lighting system designed for outdoor and emergency use. It features a high-efficiency monocrystalline solar panel, a built-in 1000-lumen LED lamp, multiple lighting modes (High, Low, SOS, Flash), a USB charging port for mobile devices, a waterproof and dustproof IP65-rated body, and a durable, collapsible stand. Powered by a built-in rechargeable lithium-ion battery that charges via solar or USB. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Solar Panel, LED Lamp Head, Control Panel, USB Port, Collapsible Stand, Carrying Handle, Battery Indicator.

Installation

Unpack and inspect contents. Choose a suitable location.

1. Unfold the stand: Extend the collapsible legs and lock them into place.
2. Position the solar panel: Ensure the solar panel faces direct sunlight for optimal charging.
3. Adjust the lamp head: Loosen the adjustment knob, point the LED lamp in the desired direction, and tighten the knob.
4. Initial charging: Before first use, charge the battery fully via solar or USB.

WARNING! Do not look directly into the LED light at close range. Ensure the unit is placed on a stable, flat surface to prevent tipping.

First-Time Setup

Charge the unit fully before initial use.

1. Charge the battery: Place in direct sunlight for 8-10 hours or connect via USB to a power adapter until the battery indicator shows full.
2. Power on: Press and hold the POWER/MODE button for 2 seconds to turn on the lamp.
3. Select mode: Press the POWER/MODE button to cycle through High, Low, SOS, and Flash modes.
4. Check USB output: Connect a USB device to verify the charging port is functional.

CAUTION! Use only the provided or manufacturer-approved USB cable for charging. Avoid extreme temperatures during charging.

Specifications

• Light Output: 1000 lumens (max).
• Solar Panel: Monocrystalline, 5W.
• Battery: Built-in Lithium-ion, 10,000mAh.
• Charging Time: Solar: 8-10 hours (full sun); USB: 6-8 hours.
• Lighting Modes: High, Low, SOS, Flash.
• Runtime: Up to 12 hours (Low mode), 4 hours (High mode).
• USB Output: 5V/2A for device charging.
• Protection Rating: IP65 (Dustproof and Water-resistant).
• Operating Temp: -10°C to 50°C.
• Weight: 1.8 kg.

Controls and Settings

All controls are located on the main control panel.

Power/Mode Button: Press once to turn on/off. Press repeatedly to cycle through modes (High → Low → SOS → Flash). Hold for 2 seconds to lock/unlock the controls.

Battery Indicator: 4 LEDs show battery level (25% per LED). Lights flash when battery is low (<10%).

USB Port: Use to charge smartphones, tablets, or other USB devices. Output automatically stops when the connected device is fully charged or if the lamp's battery is below 5%.

Connecting Devices

USB Charging: Connect your device using a standard USB cable.

1. Ensure the lamp has sufficient battery charge (at least 20% recommended).
2. Connect your device's USB cable to the lamp's USB output port.
3. Charging begins automatically. The device's screen or indicator will show charging status.
4. Disconnect the device when charging is complete.

Tip: For fastest charging, use the lamp in off mode while charging your device. Charging speed may vary based on the connected device and remaining battery.

Charging & Power Management

Supports solar and USB charging.

1. Solar Charging: Place the unit in direct sunlight. Ensure the solar panel is clean and unobstructed. The battery indicator will light up during charging.
2. USB Charging: Connect the provided USB cable to a 5V/2A adapter or computer USB port. The red charging indicator will glow steadily.
3. Battery Protection: The unit has over-charge, over-discharge, and short-circuit protection.
4. Storage: If storing for more than 3 months, charge to 50-60% and store in a cool, dry place.

WARNING! Do not disassemble the battery. Charge only in well-ventilated areas. Do not cover the solar panel or unit during charging.

Safety Features

Overload Protection: Automatically cuts off USB output in case of overload. Low Battery Warning: Flashing battery indicator when battery is below 10%. Thermal Protection: Reduces output if internal temperature exceeds safe limits. Water & Dust Resistance: IP65 rating ensures operation in rainy or dusty conditions.

Care & Cleaning

Turn off and disconnect all cables before cleaning. Use a soft, dry cloth to wipe the exterior. For the solar panel, use a slightly damp cloth and dry immediately.

CAUTION! Do not use abrasive cleaners, solvents, or water jets. Do not submerge the unit in water despite its IP65 rating.

Regulatory Information

CE Certified: Complies with European safety, health, and environmental requirements. RoHS Compliant: Free of hazardous substances. Waste Electrical and Electronic Equipment (WEEE): Do not dispose of with household waste. Recycle according to local regulations. For support, visit www.somogyi-elektronic.com or contact +36 1 234 5678.

Troubleshooting

Reset: If the unit becomes unresponsive, press and hold the POWER/MODE button for 10 seconds to force a reset.

Service: +36 1 234 5678; www.somogyi-elektronic.com