Smart Solar Frog Manual

The Smart Solar Frog is an innovative solar-powered decorative garden accessory with integrated LED lighting, automatic dusk-to-dawn operation, weather-resistant construction, and multiple lighting modes. It features a high-efficiency solar panel, rechargeable lithium battery, waterproof IP65 rating, and decorative frog design. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Solar panel with integrated LED lights, Rechargeable battery, ON/OFF switch, Mode selector, Waterproof housing, Mounting stake.

Installation

Unpack and inspect contents. Choose optimal location for sunlight exposure.

1. Select location: Choose area with direct sunlight (6-8 hours daily).
2. Assemble stake: Attach frog unit to mounting stake securely.
3. Position unit: Insert stake into ground at desired location.
4. Angle solar panel: Adjust to face south (northern hemisphere) for maximum sun exposure.
5. Initial charge: Leave in direct sunlight for 8 hours before first use.

WARNING! Do not install near flammable materials. Ensure stable placement to prevent tipping.

First-Time Setup

Power on unit; configure settings for optimal performance.

1. Initial charging: Place in direct sunlight for full day before first night use.
2. Switch position: Set ON/OFF switch to ON position.
3. Mode selection: Press mode button to choose preferred lighting pattern.
4. Light sensor test: Cover sensor to simulate darkness; lights should turn on automatically.
5. Position adjustment: Fine-tune solar panel angle for best charging.

CAUTION! Keep away from sprinklers and standing water despite waterproof rating.

Specifications

• Solar Panel: 2W monocrystalline, 5.5V output.
• Battery: 18650 lithium-ion, 3.7V 2000mAh.
• LEDs: 10 warm white LEDs, 0.5W each.
• Lighting Modes: Steady on, Slow flashing (2 sec), Fast flashing (1 sec), Fade in/out.
• Operation Time: 8-10 hours after full charge.
• Charging Time: 6-8 hours in direct sunlight.
• Waterproof Rating: IP65 (dust tight, protected against water jets).
• Dimensions: 8.5" height x 6" width x 4.5" depth.
• Weight: 1.2 lbs (with stake).
• Operating Temperature: -4°F to 122°F (-20°C to 50°C).

Controls and Settings

Access controls via buttons on underside of unit. Front Panel: ON/OFF switch, Mode button, Reset pinhole.

Operation: ON/OFF switch controls power, Mode button cycles through lighting patterns, Light sensor enables automatic operation.

Lighting Modes: Steady (constant light), Slow flash (2 second intervals), Fast flash (1 second intervals), Fade (gentle dimming cycle). Settings: Light sensitivity adjustable via internal potentiometer (factory set), Timer function for automatic shutoff after 6 hours (optional).

Connecting to Solar Panel

Integrated solar panel with direct connection to battery management system.

1. Ensure clean solar panel surface for maximum efficiency.
2. Verify connection cable is securely attached (factory pre-connected).
3. Check charging indicator LED (red when charging, off when fully charged).
4. For extended operation, consider adding external solar panel (optional accessory).

Tip: Clean solar panel weekly with soft cloth to maintain charging efficiency.

Operating Modes

Supports automatic and manual operation with multiple lighting patterns.

1. Automatic mode: Light sensor activates lights at dusk, deactivates at dawn.
2. Manual override: Switch to OFF position to disable automatic operation.
3. Mode cycling: Press mode button to sequence through patterns.
4. Memory function: Remembers last selected mode when powered off/on.
5. Energy saving: Lights automatically dim to 50% after 4 hours of operation.
6. Test mode: Hold mode button for 5 seconds to activate all LEDs for testing.

WARNING! Do not stare directly at LEDs at close range. Keep away from children's reach.

Maintenance Features

Battery Protection: Overcharge and deep discharge protection circuits. Self-Diagnosis: Flashing pattern indicates low battery (3 quick flashes). Reset Function: Press reset pinhole with paperclip for 10 seconds to restore factory settings.

Care & Cleaning

Switch to OFF position before cleaning. Use soft damp cloth only; no abrasive cleaners.

CAUTION! Do not submerge in water despite IP65 rating. Avoid harsh chemicals on solar panel surface.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits for residential use. Copyright © 2025 Smart Solar Products; trademarks of GreenTech Innovations Inc. RoHS compliant: Contains no hazardous substances. For support, visit www.smartsolarproducts.com or contact 1-800-555-1234. Battery disposal: Recycle according to local regulations.

Troubleshooting

Reset: Use paperclip in reset pinhole for 10 seconds to restore defaults.

Service: 1-800-555-1234; www.smartsolarproducts.com