Smart Living SMART SOLAR Umbrella Quick Start Manual

The Smart Living SMART SOLAR Umbrella is a solar-powered outdoor umbrella featuring a built-in solar panel, integrated LED lighting, weather-resistant polyester canopy, adjustable tilt mechanism, manual crank operation, powder-coated aluminum pole, and weighted base for stability. Designed for patios, decks, and gardens, it provides shade during the day and ambient lighting at night. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Solar panel canopy, LED light strip, Adjustable tilt mechanism, Manual crank, Aluminum pole, Weighted base, Weather-resistant fabric.

Assembly Instructions

Unpack all parts and inspect contents. Assemble on flat, stable surface.

1. Attach base: Place weighted base in desired location; fill with sand or water for stability.
2. Insert pole: Slide aluminum pole into base socket; secure with provided locking pin.
3. Install canopy frame: Attach rib arms to pole hub; ensure all connections are secure.
4. Attach canopy: Drape fabric over frame; secure with Velcro straps or fasteners at each rib end.
5. Connect solar panel: Route wiring from canopy solar panel down pole to battery compartment.
6. Install crank: Insert crank handle into side socket; test open/close mechanism.

WARNING! Umbrella is heavy; use two people for assembly. Ensure base is properly weighted before raising canopy.

First-Time Setup

After assembly, prepare umbrella for first use.

1. Charge battery: Leave umbrella in direct sunlight for 8-10 hours to fully charge battery.
2. Test lighting: Turn switch to ON after sunset; LEDs should illuminate automatically.
3. Adjust tilt: Loosen tilt knob, position canopy as desired, then retighten knob.
4. Secure location: Ensure umbrella is on level ground and base is adequately weighted.

CAUTION! Do not operate crank if canopy is obstructed. Keep solar panel clean for optimal charging.

Specifications

• Canopy Diameter: 9 feet (2.7 meters).
• Solar Panel: 10W monocrystalline solar cells.
• Battery: Built-in 12V 8Ah rechargeable lead-acid battery.
• LED Lights: 3000K warm white, 600 lumens total output.
• Light Duration: Up to 8 hours on full charge.
• Pole Material: Powder-coated aluminum, 1.5-inch diameter.
• Canopy Fabric: 180g polyester with UV50+ protection.
• Tilt Range: 0 to 90 degrees.
• Rotation: 360-degree manual rotation.
• Base Weight Capacity: Holds up to 50 lbs (22.7 kg) of sand/water.
• Weather Resistance: Water-resistant fabric; not waterproof during heavy rain.

Controls and Operation

Manual crank: Turn clockwise to open canopy, counterclockwise to close. Tilt knob: Loosen to adjust angle, tighten to lock. Light switch: ON/OFF with auto sensor.

Daily Operation: Open canopy fully for optimal shade; adjust tilt as sun moves. Close canopy during high winds or when not in use. Lights turn on automatically at dusk when switch is ON.

Storage: Close canopy and secure with strap. For long-term storage, disconnect battery if accessible, clean canopy, and store in dry location.

Solar Panel & Lighting

Solar panel charges battery during daylight; LED lights operate at night.

1. Ensure solar panel faces sunlight directly for maximum charging efficiency.
2. Battery indicator shows red while charging, green when fully charged.
3. Light sensor automatically turns LEDs on at dusk and off at dawn when switch is ON.
4. Manual override: Switch to OFF to disable lights regardless of ambient light.
5. Expected battery life: 2-3 years with proper maintenance; replace with compatible 12V 8Ah battery.

Tip: Clean solar panel weekly with soft cloth to maintain charging efficiency.

Care & Maintenance

Regular maintenance ensures longevity and optimal performance.

1. Cleaning canopy: Use mild soap solution and soft brush; rinse with water, air dry completely.
2. Cleaning solar panel: Wipe with damp cloth; avoid abrasive cleaners.
3. Pole and frame: Wipe with damp cloth to remove dirt; check for corrosion annually.
4. Battery maintenance: Keep battery compartment dry; check connections annually.
5. Winter storage: Close canopy, clean thoroughly, store in dry location; remove battery if possible.

CAUTION! Do not use pressure washer; avoid harsh chemicals. Do not open canopy when wet.

Safety Information

Read all instructions before assembly and use.

• Always weight base adequately (minimum 40 lbs/18 kg) before opening canopy.
• Close canopy during high winds (above 15 mph/24 kph) or thunderstorms.
• Keep children away from moving parts (crank, tilt mechanism).
• Do not hang items from canopy or frame; this may cause instability.
• Ensure umbrella is on level ground to prevent tipping.
• Do not attempt to repair electrical components; contact support for service.
• Keep solar panel and electrical connections dry; not designed for use in rain.

WARNING! Failure to properly weight base may result in umbrella tipping, causing injury or damage.

Warranty & Support

Smart Living SMART SOLAR Umbrella includes 2-year limited warranty covering defects in materials and workmanship. Warranty does not cover damage from misuse, improper assembly, weather events, or normal wear. For warranty claims, contact Smart Living Customer Support with proof of purchase.

Support: Email [email protected] or call 1-800-555-1234. Visit www.smartlivingproducts.com for manuals, FAQs, and parts.

Replacement Parts: Canopy covers, crank handles, and batteries available for purchase separately.

Troubleshooting

Reset: Disconnect battery for 30 seconds, then reconnect to reset lighting system.

Service: 1-800-555-1234; www.smartlivingproducts.com