Orlaco 0049500 Installation Manual

The Orlaco 0049500 is a high-performance camera system designed for industrial and vehicle applications, offering robust construction, wide dynamic range, and various mounting options. This manual provides essential information for safe installation, configuration, and initial operation. Below are the key sections covering safety, components, installation steps, wiring, configuration, and maintenance.

Safety Instructions

Read all instructions before installation. Ensure power is disconnected during wiring.

1. Install only in suitable environments (specified IP rating).
2. Use appropriate tools and personal protective equipment.
3. Secure all cables to prevent damage or disconnection.
4. Do not modify the unit or use incompatible parts.

WARNING! Incorrect installation can lead to equipment failure, injury, or void warranty. Follow local electrical codes.

Package Contents

Unpack and verify all components are present.

System Overview

Key features and interfaces of the Orlaco 0049500 system.

• Camera: High-resolution sensor with wide dynamic range (WDR).
• Lens: Fixed or varifocal lens (model dependent).
• Housing: Rugged, weatherproof enclosure (IP67 or higher).
• Connectors: Power input (12V/24V DC), video output (CVBS or digital), and control interface.
• Mounting: Universal bracket for various angles and positions.

Mounting the Camera

Select a stable location with clear field of view.

1. Position the mounting bracket at desired location.
2. Mark drill holes using bracket as template.
3. Drill holes and secure bracket with provided fasteners.
4. Attach camera to bracket and adjust angle (pan/tilt).
5. Tighten all screws to secure camera position.

Tip: Ensure mounting surface can support camera weight and vibration.

Electrical Connections

Connect power and video cables correctly.

CAUTION! Verify voltage before connecting. Use cable glands for environmental sealing.

Configuration & Setup

Basic configuration steps for initial operation.

1. Power on the camera and connected monitor.
2. Adjust camera angle for desired view.
3. Access OSD menu (if available) via control interface.
4. Set video parameters: brightness, contrast, WDR mode.
5. Configure output format (e.g., NTSC/PAL).
6. Save settings and test under operating conditions.

Note: Refer to advanced configuration guide for detailed menu options.

Technical Specifications

• Model: Orlaco 0049500
• Sensor: CMOS, 1/2.7"
• Resolution: 720TVL or higher
• Lens: 2.8-12mm varifocal (or as specified)
• WDR: >120dB
• Power Supply: 12V DC ±10% or 24V DC
• Current Consumption: <200mA @12V
• Operating Temperature: -30°C to +70°C
• Protection Rating: IP67/IP69K
• Video Output: CVBS (1.0Vp-p) or digital option

Maintenance

Regular maintenance ensures optimal performance.

1. Periodically clean lens with soft, lint-free cloth.
2. Check cable connections for corrosion or damage.
3. Verify mounting hardware remains tight.
4. Inspect housing for cracks or seal degradation.

CAUTION! Do not use abrasive cleaners or solvents on lens.

Troubleshooting

Reset: Disconnect power for 30 seconds to reset.

Warranty & Support

Orlaco products are covered by a limited warranty. For technical support, contact:

• Website: www.orlaco.com
• Email: [email protected]
• Phone: +31 (0)342 423 123

Copyright © Orlaco. All rights reserved. Specifications subject to change without notice.