The Iwerkz SolRX is a portable solar-powered charging station with integrated lithium-ion battery, multiple USB output ports (including USB-C PD), wireless charging pad, LED status indicators, built-in flashlight, weather-resistant casing, and foldable high-efficiency solar panels. Designed for outdoor and emergency use, it supports charging smartphones, tablets, small laptops, and other USB-powered devices. Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.
Key components: Foldable Solar Panel Array, Main Power Unit with battery, USB Output Ports (USB-A, USB-C PD), Wireless Charging Pad, LED Flashlight, Power Button, Status Display Screen.
| Feature | Description |
|---|---|
| Solar Panels | Monocrystalline, foldable design for optimal sun exposure |
| Battery Capacity | Integrated 20,000mAh Li-ion battery |
| USB-C PD Port | Power Delivery for fast charging compatible devices |
| USB-A Ports | Standard USB ports for charging multiple devices |
| Wireless Charging Pad | Qi-standard charging for compatible smartphones |
| LED Flashlight | Multiple modes (steady, SOS, strobe) |
| Status Display | LCD screen showing battery level, input/output power |
| POWER Button | Turns unit on/off, cycles flashlight modes |
| WEATHER-RESISTANT | IP54 rated casing for dust and water splashes |
| DC INPUT | For alternative wall charging via included adapter |
Open packaging and verify all components are present and undamaged.
WARNING! Inspect for physical damage. Do not use if solar panels are cracked or casing is compromised.
Fully charge the internal battery before first use for optimal performance.
CAUTION! Charge only in well-ventilated areas. Avoid extreme temperatures during charging.
Primary control is the POWER button. Status is shown on the LCD screen and via LED indicators.
POWER Button: Short press to turn on/off device output. Press and hold for 2 seconds to turn the entire unit on/off. When unit is off, double-press to activate flashlight and cycle through its modes.
LCD Screen Icons:
Battery Icon (%) - Current charge level.
Sun Icon - Active solar input and current wattage.
Lightning Bolt - Active output and total wattage.
Wireless Symbol - Active wireless charging.
LED Indicators (next to ports):
Green: Port is active and charging a device.
Flashing Green: Charging error or incompatible device.
Off: Port is inactive.
Connect your devices using appropriate cables to the output ports.
Tip: For fastest charging of a single device, use the USB-C PD port with a compatible cable and device.
For extended off-grid use, keep the solar panels deployed and facing the sun.
WARNING! Do not stare directly at the reflective surface of the panels. Keep away from children and pets to avoid pinching from folding mechanism.
Built-in protections for safe operation: Over-charge, Over-discharge, Over-current, Short-circuit, and Over-temperature protection. The unit will automatically shut down output if a fault is detected.
Clean with a dry, soft cloth. Do not use chemicals or abrasives.
CAUTION! Do not attempt to replace the internal battery. This voids the warranty and can be hazardous.
Iwerkz SolRX is covered by a 12-month limited warranty from date of purchase. FCC Part 15 Compliance: This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Copyright © 2025 Iwerkz Technologies. All trademarks are property of their respective owners. For customer support, visit www.iverkz-support.com or email [email protected].
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| Unit will not turn on | Battery completely drained | Charge via solar or wall adapter for 30 minutes, then try again. |
| No solar charging | Insufficient sunlight/angle | Reposition in direct sunlight; ensure panels are fully unfolded. |
| Device not charging (wired) | Faulty cable/port | Try a different cable; try a different port on the SolRX. |
| Device not charging (wireless) | Alignment/case interference | Center device on pad; remove thick phone case; ensure device supports Qi. |
| LCD screen is blank | Unit in deep sleep | Press and hold POWER button for 5 seconds to force restart. |
| Flashlight not working | Unit is in output mode | Turn unit off, then double-press POWER button for flashlight modes. |
| Unit gets very warm | High load/hot environment | Disconnect devices and allow to cool. Do not charge in direct hot sun. |
Reset: If unit behaves unexpectedly, press the small recessed RESET button on the side with a paperclip.
Service: Do not open the unit. For service, contact [email protected] or visit www.iverkz-support.com.