Furrion FSFP16MW2-BL User Manual

The Furrion FSFP16MW2-BL is a 16-inch portable refrigerator/freezer designed for mobile and off-grid applications, featuring a dual-zone compartment, AC/DC power compatibility, digital temperature control, low-voltage protection, and a durable stainless steel finish. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Power Sources 7. Operating Modes 8. Maintenance & Cleaning 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Dual-zone stainless steel compartment, Digital Control Panel, AC Power Cord, DC Power Cable, Removable Dividers, Door Lock.

FeatureDescription
Dual-Zone CompartmentSeparate refrigerator and freezer sections with independent temperature control
Digital Control PanelLCD display for temperature settings and mode selection
AC Power InputStandard 120V AC connection for household use
DC Power Input12/24V DC connection for vehicle/RV use
Low-Voltage ProtectionAutomatic shutdown to prevent battery drain
Removable DividersAdjustable compartment partitions for flexible storage
Door LockKey lock for secure operation during travel
Temperature RangeRefrigerator: 34°F to 50°F; Freezer: -4°F to 5°F
Power Mode IndicatorLED shows active power source (AC or DC)
Over-Temperature AlarmAudible alert if temperature exceeds safe limits

Installation

Unpack and inspect contents. Place on stable, level surface.

  1. Choose location: Ensure adequate ventilation (minimum 4 inches clearance on all sides).
  2. Secure unit: Use included mounting brackets if installing in vehicle/RV.
  3. Connect power: Select AC or DC power source based on application.
  4. Pre-cool: Allow unit to run empty for 2-3 hours before loading food items.

WARNING! Do not block ventilation grilles. Ensure unit is level for proper compressor operation.

First-Time Setup

Power on unit; configure initial settings.

  1. Set temperature: Use UP/DOWN buttons to set refrigerator and freezer zones separately.
  2. Select power mode: Press POWER MODE to toggle between AC and DC operation.
  3. Enable low-voltage protection: In SETTINGS menu, set DC cutoff voltage (11.5V default).
  4. Calibrate temperature: Use CALIBRATION option if external thermometer readings differ.

CAUTION! Do not overload compartment. Allow hot items to cool before placing inside.

Specifications

Controls and Settings

Access settings via front control panel. Buttons: POWER, MODE, SET, UP, DOWN.

Display Icons: AC/DC indicator, refrigerator/freezer zone icons, alarm symbol, battery level.

Temperature Settings: Independent control for each zone (34°F to 50°F refrigerator, -4°F to 5°F freezer). Power Management: AC/DC auto-switching, low-voltage cutoff (11.2V, 11.5V, 11.8V selectable). Alarms: Over-temperature, door open, power failure. Advanced: Celsius/Fahrenheit toggle, display brightness, compressor delay protection.

Connecting Power Sources

AC: Standard household outlet. DC: Vehicle/RV cigarette lighter or direct battery connection.

  1. AC Connection: Plug included cord into unit, then into grounded 120V outlet.
  2. DC Connection: Connect DC cable to unit, then to 12/24V vehicle port or battery terminals (red to positive, black to negative).
  3. Power Priority: Unit defaults to AC if both sources available; automatically switches to DC if AC disconnected.

Tip: Use appropriate fuse (10A recommended) for DC direct-wire installations.

Operating Modes

Supports refrigerator, freezer, and dual-zone operation.

  1. Refrigerator Mode: Set temperature between 34°F and 50°F for perishables.
  2. Freezer Mode: Set temperature between -4°F and 5°F for frozen items.
  3. Dual-Zone: Operate both sections simultaneously with independent temperatures.
  4. Max Cool: Press and hold DOWN for 3 seconds for rapid cooling (compressor runs continuously).
  5. Eco Mode: Reduces power consumption by optimizing compressor cycles.
  6. Vacation Mode: Maintains safe temperature while minimizing energy use during storage.

WARNING! Do not operate in ambient temperatures below 32°F. Allow unit to warm gradually if frozen.

Maintenance & Cleaning

Unplug before cleaning. Remove all food items and removable parts.

  1. Interior: Wipe with solution of mild detergent and warm water. Rinse with damp cloth.
  2. Exterior: Clean stainless steel with appropriate cleaner; avoid abrasive materials.
  3. Condenser: Vacuum dust from rear grille every 3 months for optimal performance.
  4. Door Seal: Clean with soapy water; check for proper seal periodically.

CAUTION! Never use harsh chemicals, steam cleaners, or pressure washers. Do not submerge unit.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits. UL Standard 60335-2-24: Household refrigerating appliances. California Proposition 65: Contains chemicals known to cause cancer/reproductive harm. Copyright © 2023 Furrion; trademarks of Furrion Limited. For support, visit www.furrion.com or contact 1-855-387-7466.

Troubleshooting

SymptomPossible CauseCorrective Action
Unit not coolingPower/poor ventilationCheck power connections; ensure adequate clearance; verify circuit breaker.
Display blankNo power/low voltageCheck AC/DC connections; test with alternate power source.
Alarm soundingHigh temperature/door openCheck door seal; reduce ambient temperature; reset alarm.
Excessive frostFrequent opening/humidityMinimize door openings; check seal; defrost manually if needed.
DC not workingFuse/voltageCheck vehicle fuse; verify battery voltage above cutoff setting.

Reset: Unplug for 5 minutes, then reconnect.

Service: 1-855-387-7466; www.furrion.com/support

Furrion FSFP16MW2-BL User Manual © - All Rights Reserved 2025