Fanttik EVO SOLAR 100 User Manual

The Fanttik EVO SOLAR 100 is a portable, solar-powered jump starter and power bank designed for vehicles. It features a high-capacity lithium battery, integrated high-lumen LED flashlight with SOS mode, multiple output ports (USB-A, USB-C, DC), built-in solar panel for emergency charging, intelligent jump-start clamps with reverse polarity protection, and a digital display showing battery level. It is suitable for cars, motorcycles, boats, and other 12V vehicles. Below are key sections for safety, features, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Main unit with digital display, Integrated solar panel, Intelligent jump-start clamps, LED flashlight, USB-A port, USB-C port, DC output port, Power button, Mode button.

Package Contents

Unpack and inspect all contents. Ensure nothing is missing or damaged.

1. Fanttik EVO SOLAR 100 Main Unit
2. Intelligent Jump-Start Clamps with Cables
3. USB-C Charging Cable
4. DC Adapter (if applicable)
5. Carrying Pouch
6. User Manual (this document)

WARNING! Do not use if any component appears damaged. Contact support immediately.

Safety Instructions

Read all instructions before use to prevent injury or damage.

1. Keep away from fire, water, and extreme temperatures.
2. Do not disassemble, puncture, or modify the unit.
3. Ensure correct polarity when connecting clamps to battery.
4. Do not jump-start frozen batteries.
5. Keep clamps from touching each other or metal surfaces during connection.
6. Charge the unit fully before first use and periodically for maintenance.

CAUTION! This product contains a lithium-ion battery. Risk of fire if mishandled.

Specifications

• Battery Capacity: 10000mAh Lithium-ion.
• Peak Current: 1000A for jump-start.
• Compatible Vehicles: 12V cars, trucks, motorcycles, boats, etc. (up to 7.0L gas / 5.5L diesel).
• Solar Panel: 5W, Monocrystalline.
• Flashlight: 300 Lumens, 4 modes.
• Input: USB-C 5V/3A, Solar.
• Output: USB-A 5V/2.4A, USB-C 5V/3A, DC 12V/10A.
• Operating Temperature: -4°F to 140°F (-20°C to 60°C).
• Storage Temperature: 32°F to 77°F (0°C to 25°C).

Controls and Indicators

Access functions via buttons on the unit. Front Panel: Power Button, Mode Button, Digital Display, Flashlight LED, Ports.

Digital Display: Shows battery percentage (0%-100%). LED Indicators: Flashlight modes (High, Low, SOS, Strobe). Button Functions: Power (short press to check battery/turn on flashlight, long press 3s to turn on jump-start mode); Mode (cycle flashlight modes). Audible Alerts: Beeps for incorrect clamp connection.

Initial Setup & Charging

Charge the unit fully via USB-C or solar before first use.

1. Connect the provided USB-C cable to the unit and a wall adapter (5V/3A recommended).
2. The digital display will show charging progress. Full charge takes approximately 4-6 hours.
3. For solar charging, place unit in direct sunlight. Full solar charge may take 15-20 hours.
4. Once charged, disconnect and store in a cool, dry place.

Tip: For optimal battery health, recharge when battery level drops below 20%.

Jump-Starting a Vehicle

Follow these steps carefully. Ensure vehicle is off and in park (or neutral with parking brake engaged).

1. Turn off the EVO SOLAR 100 and the vehicle's ignition.
2. Connect red clamp (+) to the positive terminal of the dead vehicle battery.
3. Connect black clamp (-) to a clean, unpainted metal part of the engine block or chassis (ground).
4. Press and hold the Power button on the EVO SOLAR 100 for 3 seconds. The display will show "READY".
5. Start the vehicle. It should start within 3-5 seconds.
6. Once vehicle is running, disconnect clamps in reverse order: Black (-) first, then Red (+).
7. Turn off the EVO SOLAR 100 by pressing the Power button.

WARNING! Do not touch clamps together. Ensure connections are secure and correct.

Using as a Power Bank

The unit can charge smartphones, tablets, GPS devices, and other USB-powered electronics.

1. Ensure the EVO SOLAR 100 is charged (check display).
2. Connect your device to the USB-A or USB-C port using your own cable.
3. Charging will begin automatically. The display will show decreasing battery level.
4. To charge the unit itself, connect a USB-C cable from a power source to its USB-C input port.

Note: The DC output port requires a compatible adapter (not included for all models).

Using the Solar Panel

The integrated solar panel provides emergency charging in sunlight.

1. Place the unit with the solar panel facing direct sunlight. Avoid shade.
2. Ensure the Power button is off. The unit will begin charging automatically.
3. Charging speed depends on sunlight intensity. It is slower than wall charging.
4. Use primarily for maintaining charge or emergency top-ups, not for full recharges.

CAUTION! Do not leave unit in extreme heat (e.g., inside a hot car) for prolonged periods.

Care & Storage

Unplug all cables before cleaning. Wipe with a dry, soft cloth. Do not use liquids or abrasive cleaners.

Storage: Store in the provided pouch in a cool, dry place (ideally between 32°F and 77°F / 0°C and 25°C). Recharge to 50%-80% every 3-6 months if storing long-term.

CAUTION! Do not expose to rain, snow, or moisture. The solar panel is water-resistant but not waterproof.

Troubleshooting

Reset: Disconnect all cables and clamps. Press and hold Power button for 10 seconds.

Service: For support, visit www.fanttik.com or contact customer service. Do not attempt to repair yourself.