Energizer HardCase Solar Sunpack 200 User Manual

The Energizer HardCase Solar Sunpack 200 is a rugged, portable solar charger designed for outdoor use. It features a high-efficiency monocrystalline solar panel, a built-in 20000mAh power bank, multiple output ports (USB-A and USB-C), IP67 water and dust resistance, a shockproof hard case, and an integrated LED flashlight. It is ideal for charging smartphones, tablets, cameras, and other USB devices while camping, hiking, or during emergencies. Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Rugged HardCase body, High-efficiency solar panel, Integrated 20000mAh Li-polymer battery, Multiple output ports, LED power indicators, LED flashlight.

Package Contents

Unpack and inspect all contents. Ensure nothing is missing or damaged.

1. Energizer HardCase Solar Sunpack 200 unit.
2. USB-A to USB-C charging cable (approx. 30cm).
3. Quick Start Guide.
4. Warranty Information Card.

NOTE: A compatible 5V/3A wall adapter is recommended for fastest charging but is not included.

First-Time Setup

Before first use, fully charge the internal power bank via the wall adapter.

1. Initial Charge: Connect the included USB-C cable to the Sunpack's INPUT port and a compatible 5V/3A wall adapter. Plug into AC power.
2. Charge Status: The 4 LED indicators will light sequentially during charging. All 4 LEDs will stay solid when fully charged (approx. 8-10 hours from empty).
3. Solar Pre-Check: Ensure the solar panel surface is clean and free of protective films.
4. Flashlight Test: Press and hold the power/flashlight button for 2 seconds to activate the LED light. Cycle through modes with short presses.

CAUTION! Use only the provided or certified cables/adapters. Do not charge in direct, extreme sunlight initially.

Specifications

• Model: HardCase Solar Sunpack 200.
• Battery Type: Built-in Li-polymer, 20000mAh / 74Wh.
• Solar Panel: Monocrystalline, 5V, 2A Max (10W).
• Input (Wall): USB-C, 5V/3A (15W Max).
• Output (Device Charging): USB-A: 5V/2.4A (12W Max per port), USB-C: 5V/3A (15W Max). Total combined output: 5V/4A (20W Max).
• Protections: Over-current, Over-voltage, Over-temperature, Short-circuit.
• Environmental Rating: IP67 (Waterproof up to 1m for 30 mins, Dustproof).
• Flashlight: LED, 3 modes (High ~100 lumens, Low, SOS).
• Weight: ~450g (0.99 lbs).
• Dimensions: 165mm x 85mm x 25mm (6.5" x 3.3" x 1").

Controls and Indicators

Power/Flashlight Button: Single press to check battery level. Press and hold for 2 seconds to turn flashlight On/Off. Short press while flashlight is on to cycle modes (High > Low > SOS > Off).

4-LED Battery Indicator: LED 1 (25%): Flashes when battery is low (<25%).
LEDs 1-2 (50%): Solid.
LEDs 1-3 (75%): Solid.
LEDs 1-4 (100%): Solid when fully charged.
LEDs flash sequentially during charging.

Ports: INPUT (USB-C): For recharging the internal battery via wall adapter.
OUTPUT (USB-A x2, USB-C x1): For charging your devices.
Solar Panel Input: Integrated panel; no separate port.

Charging the Power Bank

You can recharge the internal 20000mAh battery via wall adapter or solar.

1. Wall Charging (Recommended for Speed):
   • Use the included USB-C cable and a compatible 5V/3A wall adapter.
   • Connect the cable to the Sunpack's INPUT port.
   • Plug the adapter into a power outlet.
   • The LED indicators will flash in sequence. Charging is complete when all 4 LEDs remain solid.
   • Time: ~8-10 hours from empty.
2. Solar Charging (For Outdoor Use):
   • Place the Sunpack with the solar panel facing direct sunlight. Ensure no shadows.
   • Optimal angle is perpendicular to the sun's rays.
   • Charging will begin automatically. The LED indicators will flash.
   • Time: Varies greatly with sunlight intensity. A full solar charge may take 20-30+ hours.

WARNING! Do not leave the Sunpack unattended in extreme heat while solar charging. The surface can become very hot.

Charging Your Devices

To charge phones, tablets, or other USB devices:

1. Ensure the Sunpack's internal battery has sufficient charge (check LED indicator).
2. Connect your device to one of the OUTPUT ports using its own charging cable.
   • For fastest charging, use the USB-C port if your device supports it.
   • You can charge up to 3 devices simultaneously.
3. Charging begins automatically. Your device should show its charging icon.
4. The Sunpack's LED indicators will show the remaining internal battery level.
5. When finished, disconnect your device.

Tip: For best results, do not use the Sunpack while it is being recharged (via wall or solar).

Using the Solar Panel

The solar panel can directly charge devices or recharge the internal battery.

1. Direct Device Charging (Trickle Charge):
   • Connect your device to an OUTPUT port.
   • Place the Sunpack in direct, bright sunlight.
   • This provides a slow, steady charge ideal for maintaining a device's battery level outdoors.
   • Note: Direct solar charging is highly dependent on weather and sun angle.
2. Recharging the Internal Battery:
   • With no device connected, place the Sunpack in sunlight. It will automatically start recharging its internal battery.
   • This is the most efficient way to use solar power, storing energy for later use.

CAUTION! The solar panel is scratch-resistant, not scratch-proof. Avoid abrasive surfaces.

Care & Maintenance

To ensure longevity and performance:

• Cleaning: Wipe the solar panel and case with a soft, dry cloth. For stubborn dirt, use a cloth slightly dampened with water. Do not use chemicals or abrasive cleaners.
• Storage: Store in a cool, dry place away from direct sunlight for extended periods. Ideal charge level for long-term storage is 50-80%.
• Battery Health: For optimal battery life, avoid completely draining the internal battery frequently. Recharge it every 3-6 months if not in use.
• Water Resistance: Ensure all port covers are firmly closed before exposing to water. Rinse with fresh water after exposure to saltwater or sand, and dry thoroughly before opening ports.

WARNING! Do not attempt to disassemble the unit. There are no user-serviceable parts inside.

Safety Information

Important Safety Instructions:

1. Use only with certified USB cables and power adapters.
2. Do not expose to temperatures above 60°C (140°F) or below -10°C (14°F).
3. Do not puncture, crush, or incinerate the unit.
4. Do not submerge beyond 1 meter or for longer than 30 minutes.
5. Keep away from children. The unit contains small parts.
6. If the unit becomes abnormally hot, emits odor, or is damaged, discontinue use immediately and keep away from flammable materials.
7. This product is not a toy.

Complies with FCC Part 15 Class B. Copyright © Energizer. For support, visit www.energizer.com or contact customer service.

Troubleshooting

Reset: If the unit behaves erratically, fully drain the battery, then recharge it fully via wall adapter.

Service: For warranty or technical support, visit www.energizer.com or call 1-800-383-7323.