Egretech PSP SONIC 100W Instruction Manual

The Egretech PSP SONIC 100W is a high-performance portable power station designed for outdoor adventures, emergency backup, and off-grid applications. It features a 100W pure sine wave AC output, multiple DC ports (USB-A, USB-C, 12V carport), a high-capacity lithium battery, MPPT solar charging capability, an LCD display for status monitoring, and built-in safety protections. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Charging the Power Station 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: High-capacity Lithium Battery, Pure Sine Wave AC Inverter, LCD Display, Solar Charge Controller, Multiple Output Ports, Carrying Handle.

Feature	Description
AC Output	100W Pure Sine Wave (120V, 60Hz)
DC Outputs	2x USB-A (5V/2.4A), 1x USB-C PD (60W), 1x 12V Car Socket
Battery Capacity	296Wh Lithium-ion
Charging Input	AC Wall Charger, Solar Panel (11-28V DC), 12V Car Charger
LCD Display	Shows battery level, input/output power, warnings
Safety Protections	Overload, Overheat, Short Circuit, Low Voltage Protection
Power Button	Turns AC/DC outputs on/off
LCD Button	Toggles display backlight on/off
DC Output Button	Enables/disables all DC ports
AC Output Button	Enables/disables AC inverter

Installation

Unpack and inspect contents. Place on stable, dry surface.

Initial Charge: Connect included AC adapter to wall outlet and to power station's DC input port.
Positioning: Ensure unit is placed in a well-ventilated area, away from direct sunlight, heat sources, and moisture.
Connecting Loads: Connect devices to appropriate output ports after power station is charged and powered on.
Solar Setup (Optional): Connect compatible solar panel to DC input port using provided cable.

WARNING! Do not disassemble or modify the unit. Keep away from children and pets. Avoid exposure to water.

First-Time Setup

Power on the unit; monitor LCD display.

Fully charge the battery: Connect to AC wall charger until LCD shows 100%.
Configure settings (if applicable): Use button combinations (see Controls) to set auto-shutdown timer or battery saver mode.
Test outputs: Connect a small device (e.g., phone charger) to a USB port to verify operation.
For solar charging: Angle solar panel towards sun, connect to DC input, ensure LCD shows charging icon.

CAUTION! Use only provided or manufacturer-approved cables and adapters. Do not exceed rated power output.

Specifications

Model: PSP SONIC 100W.
Battery Type: Lithium-ion, 296Wh.
AC Output: 100W Pure Sine Wave, 120VAC, 60Hz.
DC Outputs: USB-A: 5V/2.4A (x2), USB-C PD: 60W Max, 12V Car Socket: 10A Max.
Input: AC Charger: 24V/3A, Solar: 11-28V DC, 120W Max.
Display: LCD with battery percentage, input/output wattage, error codes.
Operating Temp: 32°F to 104°F (0°C to 40°C).
Weight: Approx. 6.6 lbs (3 kg).
Dimensions: 9.1 x 5.5 x 7.9 in (23 x 14 x 20 cm).

Controls and Settings

Front Panel: POWER Button, LCD Button, AC Output Button, DC Output Button.

LCD Display Icons: Battery Level, AC/DC Output Active, Charging Input Active, Overload/Error Warning.

Settings (accessed by holding buttons): Hold POWER + LCD for 3 seconds to toggle battery percentage/voltage display. Hold DC Button for 5 seconds to enable/disable auto-shutdown (after 12 hours of no load).

Connecting Devices

AC Devices: Plug into AC outlet (max 100W). DC Devices: Use appropriate USB or 12V car port.

Ensure power station is on and battery level is sufficient.
Check device power requirements (do not exceed port/station limits).
Connect device cable securely.
Press corresponding output button (AC or DC) if output is disabled.

Tip: For high-power AC devices (like small laptops), ensure total load is under 100W to avoid overload shutdown.

Charging the Power Station

Supports AC wall charging, solar charging, and 12V car charging.

AC Charging: Use included adapter. Connect to wall outlet, then to DC input port. LCD shows charging animation.
Solar Charging: Use compatible solar panel (11-28V DC, max 120W). Connect panel to DC input. Ensure good sunlight.
Car Charging: Use optional 12V car charger cable. Plug into vehicle's 12V socket and unit's DC input.
Charging Time: Approx. 6-7 hours from 0% via AC adapter; solar time varies with panel wattage and sunlight.

WARNING! Do not charge in extreme temperatures. Use only manufacturer-approved solar panels. Disconnect when not in use.

Safety Features

Overload Protection: Automatically shuts off output if load exceeds rating. Overheat Protection: Reduces output or shuts down if internal temperature is too high. Short Circuit Protection: Cuts power if short is detected. Low Voltage Protection: Automatically turns off to prevent battery damage when voltage is too low.

Care & Cleaning

Power off and disconnect all cables before cleaning. Use a soft, dry cloth to wipe exterior. For stubborn dirt, use a cloth slightly dampened with water. Do not use chemicals or abrasives.

CAUTION! Never immerse in water or allow liquids to enter ports. Store in a cool, dry place when not in use for extended periods.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits for residential use. CE, RoHS compliant. Copyright © 2025 Egretech; trademarks of Egretech Inc. For support, visit www.egretech.com or contact 1-800-555-EGRE. Battery disposal: Follow local regulations for lithium-ion battery recycling.

Troubleshooting

Symptom	Possible Cause	Corrective Action
No power output	Battery depleted, output disabled	Recharge battery; press AC or DC output button to enable.
LCD not displaying	Unit off, display sleep	Press POWER button; press LCD button to wake display.
Overload warning/shutdown	Connected device exceeds 100W	Disconnect device, reduce load, restart unit.
Not charging from solar	Insufficient sunlight, wrong cable	Ensure panel in direct sun; use correct solar charging cable.
Rapid battery drain	High load, old battery	Check connected device power draw; battery may need replacement if old.

Reset: Disconnect all devices, turn unit off, wait 1 minute, then restart.

Service: 1-800-555-EGRE; www.egretech.com/support