Cogex SolarLine 313196 Instruction Manual

The Cogex SolarLine 313196 is a high-efficiency solar-powered outdoor lighting solution designed for pathways, gardens, and landscape illumination. Featuring monocrystalline solar panels, integrated lithium-ion battery, automatic dusk-to-dawn operation with motion sensor capability, IP65 waterproof rating, and adjustable mounting. Powered entirely by solar energy with backup charging via micro-USB. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Monocrystalline solar panel, LED light array (3000K warm white), PIR motion sensor, Lithium-ion battery pack, Weatherproof housing, Mounting bracket with adjustable angle.

Installation

Unpack and inspect contents. Choose optimal location for maximum sunlight exposure.

1. Select location: Ensure solar panel faces south (northern hemisphere) with direct sunlight for 6-8 hours daily.
2. Ground installation: Insert stake into firm soil; attach light unit to stake.
3. Wall installation: Use included bracket and screws; mount at recommended height (6-8 feet).
4. Adjust angle: Tilt solar panel to optimal angle for your latitude (typically 15-45 degrees).
5. Initial charging: Before first use, charge via solar for 8 hours or micro-USB for 6 hours.

WARNING! Do not install near heat sources or flammable materials. Ensure mounting surface is secure.

First-Time Setup

After installation, configure operating settings for optimal performance.

1. Power switch: Turn ON/OFF switch to ON position (located on bottom of unit).
2. Mode selection: Press MODE button to cycle through operating options (Constant, Sensor, Auto).
3. Sensor adjustment: Use sensitivity dial to set motion detection range (Min to Max).
4. Duration setting: Adjust timer dial for light duration after motion detection (10s to 60s).
5. Test operation: Cover solar panel to simulate darkness; verify automatic activation.

CAUTION! During initial setup, ensure solar panel is exposed to sunlight for proper charging.

Specifications

• Model: SolarLine 313196
• Solar Panel: Monocrystalline, 6V/3W
• LED Output: 800 lumens, 3000K warm white
• Battery: Lithium-ion 18650, 5200mAh, 3.7V
• Charging Time: 6-8 hours (solar), 5-6 hours (USB)
• Light Duration: Up to 12 hours (constant), 3-5 days (motion sensing)
• Motion Sensor: PIR, range 3-8 meters, 120° detection angle
• Weatherproof: IP65 rated (-20°C to 50°C operating temperature)
• Dimensions: 280mm x 180mm x 85mm
• Weight: 850g
• Warranty: 2 years limited warranty

Controls and Settings

Access controls via buttons and dials on the unit. Control Panel: ON/OFF switch, MODE button, Sensitivity dial, Duration dial.

Operating Modes: MODE 1 - Constant On (dusk-to-dawn), MODE 2 - Motion Sensor Only, MODE 3 - Dusk-to-Dawn + Motion Boost.

Sensor Settings: Adjust sensitivity for pet immunity or maximum range. Duration Settings: Set how long light remains on after motion detection. Charging Indicator: LED shows charging status (red=charging, green=fully charged).

Connecting to Power Source

Primary: Solar panel (automatic). Backup: Micro-USB port for emergency charging.

1. Solar charging: Ensure panel is clean and facing direct sunlight.
2. USB charging: Connect included cable to any 5V/2A USB power source.
3. Charging indicator: Red LED indicates charging; green indicates full charge.
4. Battery protection: Built-in overcharge and deep discharge protection.

Tip: For optimal performance, clean solar panel weekly and ensure no shading during peak sun hours.

Operating Modes

Three operating modes for different lighting needs.

1. Constant Mode: Light turns on at dusk, remains on until dawn at 30% brightness.
2. Motion Only: Light remains off until motion detected, then activates at 100% brightness for set duration.
3. Auto Mode: Light remains at 30% brightness from dusk to dawn, boosts to 100% when motion detected.
4. Manual override: Turn ON/OFF switch to OFF position to disable all functions.
5. Test mode: Cover solar panel completely for 5 seconds to test light activation.

WARNING! Do not stare directly at LED lights at close range. Keep away from children's direct line of sight.

Maintenance & Care

Regular maintenance ensures optimal performance and longevity.

1. Cleaning: Wipe solar panel with soft, damp cloth weekly to remove dust and debris.
2. Battery care: If not using for extended periods, charge fully every 3 months.
3. Winter care: Remove snow accumulation from solar panel promptly.
4. Inspection: Monthly check of mounting stability and housing integrity.
5. LED maintenance: LEDs have 50,000-hour lifespan; no user replacement required.

CAUTION! Do not open housing or attempt to replace battery. Use only approved micro-USB charger.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits for residential use. CE certified for European market. RoHS compliant. Copyright © 2023 Cogex Solar Technologies; all rights reserved. For support, visit www.cogexsolar.com or contact 1-800-555-2837. Disposal: Follow local regulations for electronic waste; do not dispose with household trash.

Troubleshooting

Reset: Turn OFF for 30 seconds, then ON while covering solar panel completely.

Service: 1-800-555-2837; www.cogexsolar.com/support