Bougerv 9BB-130W User Manual

The Bougerv 9BB-130W is a high-performance 130W portable power station designed for outdoor adventures, emergency backup, and off-grid power needs. It features a 299Wh lithium-ion battery, multiple output ports (AC, DC, USB), pure sine wave AC inverter, MPPT solar charging capability, LCD display for status monitoring, and robust safety protections. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Lithium-ion Battery Pack, Pure Sine Wave Inverter, LCD Display, Multiple Output Ports, Solar Charge Controller, Carrying Handle.

Installation

Unpack and inspect contents. Place on stable, dry surface away from heat and moisture.

1. Initial Charge: Connect the included AC adapter to the unit's AC input port and a wall outlet. Charge fully before first use.
2. Positioning: Ensure adequate ventilation around the unit; do not block cooling vents.
3. Accessory Check: Verify all cables and adapters are present and undamaged.

WARNING! Do not expose to water, rain, or extreme temperatures. Keep away from flammable materials.

First-Time Setup

Power on the unit; monitor LCD display for status.

1. Initial Power-Up: Press and hold the power button for 3 seconds. The LCD will illuminate.
2. Battery Calibration: For accurate readings, perform a full charge/discharge cycle initially.
3. Output Selection: Use the mode button to cycle between AC, DC, and USB outputs as needed.
4. LCD Settings: The display shows remaining battery percentage, estimated runtime, and active output wattage.

CAUTION! Use only provided or manufacturer-approved charging cables and adapters.

Specifications

• Battery Capacity: 299Wh, Lithium-ion.
• AC Output: 130W Pure Sine Wave, 110V, 60Hz.
• DC Output: 12V/10A (Car Port), 12V/3A (DC5521).
• USB Outputs: 2x USB-A QC3.0 (18W max each), 1x USB-C PD (60W max).
• Input Charging: Solar (11-28V, 100W max), Car (12-24V), AC Wall (100-240V).
• Cycle Life: 800+ cycles to 80% capacity.
• Display: LCD with battery level, input/output power, error codes.
• Operating Temp: 32°F to 104°F (0°C to 40°C).
• Storage Temp: -4°F to 113°F (-20°C to 45°C).
• Weight: Approx. 6.6 lbs (3 kg).

Controls and Settings

Access functions via front panel buttons and LCD display.

Front Panel: Power Button (press and hold 3 sec to turn on/off), Mode Button (cycle outputs), LCD Display, Output Ports.

LCD Icons: Battery Level (%), Input/Output Power (W), Estimated Runtime, Warning Indicators (overload, high temp). Settings: Press and hold Mode button for 5 seconds to enter ECO mode (auto power-off when no load). Press Power button twice quickly to enable/disable LCD backlight.

Connecting Devices

Connect devices to appropriate output ports based on power requirements.

1. AC Devices: Plug into the AC outlet (max 130W continuous). Ensure device power rating is within limit.
2. DC Devices: Use 12V car port for car appliances or DC5521 port for compatible devices.
3. USB Devices: Connect smartphones, tablets, lights to USB-A or USB-C ports.
4. Simultaneous Use: Total output across all ports must not exceed 130W.

Tip: Start with the device powered off, connect it, then turn on the device and the power station's output.

Charging the Unit

Supports three charging methods: Solar, Car, and AC Wall.

1. AC Wall Charging: Connect included adapter to AC input port and wall outlet. Charging time: ~6-7 hours.
2. Car Charging: Use 12V car charger cable (optional) plugged into car cigarette lighter. Charging time: ~8-9 hours.
3. Solar Charging: Connect compatible solar panel (11-28V, max 100W) via MC4 to DC input. Optimal in direct sunlight.
4. Charging Status: LCD shows input power (W) and battery level increasing. Fan may activate during charging.

WARNING! Use only solar panels with voltage within specified range. Do not charge in extreme heat.

Safety Features

Built-in protections: Overload Protection (shuts off output if exceeds 130W), Short-Circuit Protection, Over-Voltage Protection, Over-Temperature Protection (auto fan cooling), Low-Temperature Charging Protection (prevents charging below 32°F/0°C).

Care & Maintenance

Store in cool, dry place. Clean with dry cloth; do not use liquids. For long storage, charge to 50-60% and recharge every 3 months.

CAUTION! Do not disassemble; no user-serviceable parts inside. Avoid dropping or physical impact.

Regulatory Information

FCC Part 15: Class B digital device; complies with interference limits. CE, RoHS compliant. Copyright © 2025 Bougerv; trademarks of Bougerv Inc. For support, visit www.bougerv.com or contact [email protected].

Troubleshooting

Reset: Disconnect all devices, turn off unit, wait 1 minute, then restart.

Service: [email protected]; www.bougerv.com/support